Files (2)

seatback_1.stl

STL

50.8 KB

seatback_3.stl

STL

56.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
seatback_1.stl	Printable file	50.8 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level to avoid clogging issues with certain filaments
seatback_3.stl	Printable file	56.8 KB STL	Slice file	Slice file	Slice file	Ensure the print bed is level to avoid clogging issues with certain filaments

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Purse or trash hook for car

0 downloads42 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I had made some seat back hooks from thingiverse for trash and my mom wanted a set that could hold her purse so I got out the calipers and took some measurements and printed this. It was designed around the headrest of a 2015 Ford Edge and the back of the seat distance and such. But also around her big a$$ purse. I printed two at 30% infill with gyroid pattern. One will hold her purse with both handles of the purse on top of one another. But I did the second one (pictured translucent green) to distribute the weight and give to relief to each and the purse handles. The other one (not pictured yet) started off with Solutech silver as my printer does not like glossy black filament if the bed is not perfectly level (clogs up). It may also have other hanging uses.