Samsung Galaxy S5 holder on Hyundai Tucson 2009 - image

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

0 model files

Recommended kit

—

Based on 25% main infill across listed model files

Material cost

$0.00

Filament only at roughly $24/kg PETG / ASA

Print time

—–—

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Samsung Galaxy S5 holder on Hyundai Tucson 2009

0 downloads39 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of the two things: A vertically holding Samsung Galaxy S5 holder A Hyundai Tucson (2009-) ticker holder attacher The original ticker holder attacher for Tucson comes with its own adaptive phone holder, which I don't have. Customization done: 1.cut the phone holder's top half back so that the whole thing doesn't take too much attention in the car while the phone is not there 2.cut the tongue of the ticket holder attacher a bit short to make it align with the phone holder. 3.make it more solid on the connection of the fake ticket and the phone holder.