Servo mount to push away the infoscreen - image

Files (1)

Feste.STL

STL

50.5 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

11g

Based on 25% main infill across listed model files

Material cost

$0.27

Filament only at roughly $24/kg PETG / ASA

Print time

19m–31m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Feste.STL	Primary model	50.5 KB STL	10g $0.24	11g $0.27	24g $0.58	Ensure proper orientation in the slicer for optimal printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Servo mount to push away the infoscreen

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Servo mount to push away the infoscreen. SG90 Servo. Use arduino to run servo. Code: /* Sweep by BARRAGAN This example code is in the public domain. modified 8 Nov 2013 by Scott Fitzgerald http://www.arduino.cc/en/Tutorial/Sweep */ #include Servo myservo; // create servo object to control a servo // twelve servo objects can be created on most boards int pos = 0; // variable to store the servo position void setup() { myservo.attach(9); // attaches the servo on pin 9 to the servo object } void loop() { delay(25000); for (pos = 0; pos = 0; pos -= 1) { // goes from 180 degrees to 0 degrees myservo.write(pos); // tell servo to go to position in variable 'pos' delay(15);// waits 15ms for the servo to reach the position exit(0); } }.