Shorty Center Console for NB Miata - image

Files (3)

Console_Split-_Rear.stl

STL

1.7 MB

Console_Full.stl

STL

2.9 MB

Console_Split-_Front.STL

STL

1.2 MB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Console_Split-_Rear.stl	Printable file	1.7 MB STL	Slice file	Slice file	Slice file	Print upside down to avoid support removal issues
Console_Full.stl	Printable file	2.9 MB STL	Slice file	Slice file	Slice file	Print upside down to avoid support removal issues
Console_Split-_Front.STL	Printable file	1.2 MB STL	Slice file	Slice file	Slice file	Print upside down to avoid support removal issues

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Shorty Center Console for NB Miata

0 downloads457 views0 likes

Shared by

Michael Chen

Verified

Description

Shorty center console to cover up the gaping hole left behind when removing the stock transmission tunnel cover, as well as cover the lower shifter boot. This design allows you to use your stock NB Miata shifter boot and shifter boot retainer. You'll probably need to open up the screw holes on your boot retainer, but nothing that would prevent you from going back to stock. This attaches to the center stack using the stock screws from the original piece. HIGHLY HIGHLY recommend printing this upside down. If printed "right side up", the supports will be nearly impossible to remove without damaging/destroying the boot retainer screw pegs. For printing in one piece, have at it. I don't have experience with this printed whole, but I don't imagine it would be a problem. Just print upside down and with your favorite supports and temperatures. I don't have a printer large enough to do this in one piece, so I've included STL's to print in two pieces:.

Print Settings

Time: 2h

Filament: 50g

Supports: Not needed

Compatible Cars

Mazda MX-5

Published Feb 13, 2026Updated Jul 15, 2026

Originally published on thingiverse.com · License: CC BY

Verified by drivers

Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.

Loading fitment proof…

Comments (0)

Part lists

BMW

3.1K

License: CC BY

View & download STL files