Files (1)

Silverado_Cubby_Gauge_Pod.stl

STL

154.0 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Silverado_Cubby_Gauge_Pod.stl	Primary model	154.0 KB STL	Slice file	Slice file	Slice file	Ensure a good fit by removing old clips from the original cubby

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Silverado Cubby Gauge Pod

0 downloads47 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a gauge pod I designed for my 2005 Silverado 2500. It's the cubby just below the center dash vent. Not on all Silverado's though. Once you remove the old cubby, you need to remove the old clips which can be a pain. But are necessary to a good fitment in your truck. Replaces GM15766229 Cubby so check to see if this looks like yours. Gauge is a 2" and hole in center of part is angled to fit with the angled bezel. ( I am using a GlowShift and it fits perfectly with the bezel included with the gauge).