Subaru Legacy Clock / Trip Relocation Bracket - image

Files (2)

Back.stl

STL

157.7 KB

Face.stl

STL

116.2 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

2 model files

Recommended kit

29g

Based on 25% main infill across listed model files

Material cost

$0.70

Filament only at roughly $24/kg PETG / ASA

Print time

50m–1.4h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Back.stl	Printable file	157.7 KB STL	14g $0.34	15g $0.37	34g $0.81	Print in a temperature-resistant material due to potential heat exposure from the car's interior.
Face.stl	Printable file	116.2 KB STL	13g $0.31	14g $0.33	31g $0.73	Print in a temperature-resistant material due to potential heat exposure from the car's interior.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Subaru Legacy Clock / Trip Relocation Bracket

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I have made this model as any other model If found here or on the internet had poor fitment on my car. This fits almost perfectly to a 2009 Subaru Legacy (B4). This model relocates the clock to the ash tray and lighter hole. Print the two parts in a temperature resistant filament and glue with epoxy, I recommend to sand, fill and paint them as I will do in the near future. See printing orientation in the pictures attached. I have invested a whole spool+ some 50 printing hours and 7 hours designing it excluding many iterations, if it fits you well throw a buck in my paypal:) alexsh89@gmail.com.