Subaru Outback BH - door speaker mounts - image

Files (3)

Left_front_speaker_mount.stl

STL

107.7 KB

Rear_speaker_mount.stl

STL

86.0 KB

Right_front_speaker_mount.stl

STL

108.2 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

3 model files

Typical selected file

22g

Based on 63% main infill for the largest likely-needed model file

Material cost

$0.52

Filament only at roughly $24/kg PETG / ASA

Print time

37m–1.0h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 63%	100% solid	Recommendation
Left_front_speaker_mount.stl	Choose left variant	107.7 KB STL	13g $0.30	22g $0.52	30g $0.72	Use PETG / ASA, 4 walls, 63% infill. Pick the matching side before printing.
Rear_speaker_mount.stl	Mount / bracket	86.0 KB STL	12g $0.28	20g $0.49	28g $0.67	Verify orientation and supports in your slicer
Right_front_speaker_mount.stl	Choose right variant	108.2 KB STL	13g $0.30	22g $0.52	30g $0.72	Use PETG / ASA, 4 walls, 63% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Panels

Subaru Outback BH - door speaker mounts

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I recently blew the door speakers in my Australian 2003 Subaru Outback wagon only to find i needed to make a mount to allow the fitment of new aftermarket speakers. The following STLs will fit the three-point fitment holes in BH Outbacks 1999-2003. You'll need to print two rear and one of each front as they are angled. The door skins will fit perfectly over the mounts no problem. I printed mine in PolyMaxx at 75% infill as I wanted something solid to screw the speakers to, but that may have been overkill. No supports required. I also suggest some sort of stick on foam strip like door sealer on the face that touches the door to prevent rattles and make a better seal for bass.