Superhero speaker adapters Ioniq - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Panels

Superhero speaker adapters Ioniq

0 downloads42 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Adapters to fit aftermarket speakers to the Hyundai Ioniq. Front and rear doors used 6.5" speakers 4Ohm. The woofer uses an 8" speaker 2x2Ohms. You need to print 4pcs of the door adapter and one woofer adapter. Do not forget to replace the tweeters too, they make a massive difference!! You need 4pcs of 5mm wood screws to fit the adapter to the woofer casing. They ned to be cut to a flat nose and in total 45-50mm long. Ikea got the exact right screws but I do not have the part number for those. (5x50mm hex) Add some sort of seal between the casing and adapter. PL400 or equivalent would do. Remember to add non-woven polyeter foam too before assembly. If you came this far I'm certain most of it is obvious already...:-).