Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Suspension_Strut_Top_Mount_Cover_For_Nissan_Leaf.stl | Cover / cap | 294.4 KB STL | Slice file | Slice file | Slice file | Use PETG / ASA; check sealing faces and verify in slicer. |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Suspension strut top mount cover for Nissan Leaf
Shared by
3DPrintedCarPartDescription
The suspension strut of the nissan leaf is not properly protected and water will pool up causing corrosion and expensive repairs. This simple cap will snap right on if you push it firmly down over the strut top, protecting it from water and other goo that might end up there. Some leafs have a small cover that does not provide sufficient protection, but my leaf had no cover at all. Designed for the 2018-2022 generation of leafs, but might fit the older generation.
Compatible Cars
Originally published on thingiverse.com by Ingemar Fällman (Mr_Smurf) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
