Tesla | Card holder / Card wallet - image

Files (2)

TeslaLogo.obj

OBJ

119.4 KB

TeslaWallet.obj

OBJ

88.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
TeslaLogo.obj	Printable file	119.4 KB OBJ	Slice file	Slice file	Slice file	Ensure proper adhesion to the print bed to avoid warping
TeslaWallet.obj	Printable file	88.5 KB OBJ	Slice file	Slice file	Slice file	Ensure proper adhesion to the print bed to avoid warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Tesla | Card holder / Card wallet

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I've recently bought a Tesla Model 3 and needed a card holder for the key to the card, thought I might aswell make it similar. The Tesla logo is put into the 3 holes then superglued into place, has never fallen off for me and works like a charm. The card holder holds 5 cards total, you could probably squish in a bit more if you'd like. depending on the thickness of the cards.