Files (2)

98.7_Scaled_Short_Cap.stl

STL

84 B

tesla_model_3_lugnut_cover.stl

STL

111.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
98.7_Scaled_Short_Cap.stl	Cover / cap	84 B STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
tesla_model_3_lugnut_cover.stl	Cover / cap	111.6 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Tesla lugnut cover

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Lugnut cover for the Version 2 tesla lugnuts. 21 mm internal diameter 1.4225 cm tall(the section that goes around the lugnut) Tesla logo on front. make sure that the first layer is not too close to the bed or else the logo will not look good. Tested on other vehicles with 21mm lug nuts, but never tested on Tesla. If you try to print it and you have a Tesla, please let me know if it works. I recommend using the 98.7% scaled shorter version of the cap, as it does not protrude as for from the tire, giving it a much cleaner look.