Tesla Model 3 glovebox organizer shelf - image

Files (5)

divider.stl

STL

89.6 KB

floor_side.stl

STL

62.2 KB

mid.stl

STL

191.7 KB

mid_side.stl

STL

77.8 KB

side.stl

STL

98.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

5 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
divider.stl	Printable file	89.6 KB STL	Slice file	Slice file	Slice file	Print all required pieces and assemble on a flat surface
floor_side.stl	Printable file	62.2 KB STL	Slice file	Slice file	Slice file	Print all required pieces and assemble on a flat surface
mid.stl	Printable file	191.7 KB STL	Slice file	Slice file	Slice file	Print all required pieces and assemble on a flat surface
mid_side.stl	Printable file	77.8 KB STL	Slice file	Slice file	Slice file	Print all required pieces and assemble on a flat surface
side.stl	Printable file	98.8 KB STL	Slice file	Slice file	Slice file	Print all required pieces and assemble on a flat surface

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Tesla Model 3 glovebox organizer shelf

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Just got the Tesla Model 3 a few months ago. One bothersome thing in it (and all my cars really) is that the glovebox is always a disorganized pile of mess. The glovebox on the model 3 has some weird angles. But this shelf snaps together and should fit nicely in the glovebox, leaving a little nook on the right side of the glovebox for the charge head adapter. Print 2x side, 2x divider, 2x floor_side, 2x mid, 2x mid_side pieces and snap them together on a hard flat surface with some thumb pressure. FYI the "mid_side" are not symmetrical. You will have to flip one upside down to get the pegs to line up with the "side" piece. Also it much easier to piece together the top "shelf" first on a flat surface and then attach the "side" and "divider" pieces and finally attach down to the "floor pieces".