Files (1)

Tesla_Model_3_umbrella_hanger.stl

STL

486.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tesla_Model_3_umbrella_hanger.stl	Primary model	486.3 KB STL	Slice file	Slice file	Slice file	Ensure a brim or raft is used for stability if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Tesla Model 3 umbrella holder

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Even though I don't often use them, I like to keep a couple of umbrellas in the car - just in case. To keep them tucked away I made two holders to hang them just behind the seats under the parcel shelf. They fit into the roughly 16 mm holes at the ends and are secured in place by a screw through the middle.