Files (1)

Suporte_iPhone_8_Tesla.STL

STL

741.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Suporte_iPhone_8_Tesla.STL	Primary model	741.5 KB STL	Slice file	Slice file	Slice file	Ensure a tight fit by gluing foam on the 'claws' if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Tesla Model S Phone Holder

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This phone holder was designed with measurements based on the Tesla Model S and the iPhone 8 with a slim cover, but it is quite universal. It also fits the iPhone 8 Plus with a thick case and its overall design allows for larger phones and probably even similar dashboards (untested). If the phone has a silicone/rubber case, it is enough so it doesn't slide around, otherwise, I would recommend glueing some foam, to have a tighter fit on the phone. This design was intended to glue some foam on the "claws", this allows for a tight fit without denting the dashboard.