Toyota GR Yaris Headrest Gopro Mount - image

Files (2)

GR_Yaris_Headrest_Gopro_mount_LHD_v20.stl

STL

198.6 KB

GR_Yaris_Headrest_Gopro_mount_RHD_v20.stl

STL

198.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
GR_Yaris_Headrest_Gopro_mount_LHD_v20.stl	Mount / bracket	198.6 KB STL	Slice file	Slice file	Slice file	Print in the direction as pictured for maximum strength
GR_Yaris_Headrest_Gopro_mount_RHD_v20.stl	Mount / bracket	198.6 KB STL	Slice file	Slice file	Slice file	Print in the direction as pictured for maximum strength

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Toyota GR Yaris Headrest Gopro Mount

0 downloads100 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The GR Yaris seat vibrates a bit, so you either need video stabilization which solves this very well or you can try to have a strap attached to the rear seat's ISOFIX, pulling on the seat back to stabilize it. ------- Print in direction as pictured above for maximum strength Print with __minimum four__ perimeters (walls) Use supports from building plate only ------- If the 3D printed mount is too hard to slide onto the headrest's mounting rods please slightly file down the ridges found inside the 3D printed mounting holes. They are there to make the mount sit tight on the rods. See picture above. There are also two holes with spaces for M4 nuts and screws. This is optional, to fasten the mount to the headrest 's two rods if it isn't as tight as it should be. If you use this don't overtighten!