Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Trash Bin for BMW vehicles

0 downloads36 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a trash bin for the BMW i3 that connects to the accessory slots in front of the middle console. I made it to work around the extra cup holder if you keep that in the middle slot. The accessory slot connector was made with 70% infill for strength. It took less than 2 hours to complete. The bin was made with 20% infill but took a whopping 18 hours to build. I wanted the bin to reach all the way to the floor so there was no stress on the connector. I could have put small feet under the bin to make it smaller and thus less filament but this was my first run at this Thingy.