VW Jetta Wheel Cover Cap (55.7mm OD) - image

Files (1)

VW_Jetta_Wheel_Cover_Cap.stl

STL

700.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
VW_Jetta_Wheel_Cover_Cap.stl	Cover / cap	700.2 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and supports likely, verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

VW Jetta Wheel Cover Cap (55.7mm OD)

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This wheel cover / cap fits the ~60mm opening on the center of a VW Jetta 15" wheel (designed to fit a 2004 Jetta TDI wheel). I printed this in the dome-facing-up orientation with supports and 0.16mm layer height settings with good results -- fits nicely. Fusion 360 project file available here: https://a360.co/2RN4lYX