Wrangler TJ universal Mobile Phone holder for your Smartphone - image

Files (4)

hook.stl

STL

84.4 KB

Klemme.stl

STL

135.3 KB

Klemme_L.stl

STL

134.5 KB

Klemme_R.stl

STL

134.5 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

4 model files

Typical selected file

15g

Based on 25% main infill for the largest likely-needed model file

Material cost

$0.35

Filament only at roughly $24/kg PETG / ASA

Print time

25m–42m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
hook.stl	Printable file	84.4 KB STL	12g $0.28	13g $0.30	28g $0.67	Ensure a secure fit in the air vent slots
Klemme.stl	Printable file	135.3 KB STL	13g $0.32	15g $0.35	32g $0.77	Ensure a secure fit in the air vent slots
Klemme_L.stl	Printable file	134.5 KB STL	13g $0.32	15g $0.35	32g $0.77	Ensure a secure fit in the air vent slots
Klemme_R.stl	Printable file	134.5 KB STL	13g $0.32	15g $0.35	32g $0.77	Ensure a secure fit in the air vent slots

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Wrangler TJ universal Mobile Phone holder for your Smartphone

0 downloads69 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

A simple universal smartphone car holder for your TJ with a quick release button on top. Just clip the rear side inside the thin air vent slots and adjust it for your smartphone. Testet with my Elephone P9000 with a silicon case. Whithout a Silicon case i would recommend to use some foam-rubber on the bottom for better grip. --------====UPDATE====---------- added another 2 variations of the top part with the release button on left and right side.