XRAD'S Land Rover Discovery 2 License Plate Light Surround
Files (2)
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
Pickle Rick (XRAD)Designers selling from the US, Canada, the UK, the EU/EEA (except Iceland), Switzerland and Gibraltar can also list separate original designs for sale and receive 80% of the listing price, paid out by Stripe in your local currency (conversion fees may apply). Claiming credits you here; it doesn't put this imported part up for sale.
Description
Tired of those dim license plate lights? Get some 3w led lights off ebay Eagle eye LEDs 3w: https://www.ebay.com/itm/20X-3W-LED-DRL-Eagle-Eye-Car-Fog-Daytime-Reverse-Backup-Parking-Signal-Light-12V-/222328451370 and print this housing. Uses a 500ohm (or close) resistor on the positive lead as lights are a bit too bright for license plate needs. Don't worry, if you hook up reverse polarity, led does not fry. Re-use the OEM rubber surround and the spade connectors. Use some new #6 speed nuts(timmerman nuts) and #6 stainless screws to hold in place. #8 might work too but you have to make some room for the nut. A dab of 2-part devcon plastic welder to hold the nut and seal the LED housing to the surround, and a bit of heat shrink and good to go. I provided a 3D print with round PADS as well as the base model. Padded one prints for me better than brim or rim.
Compatible Vehicles
Originally published on thingiverse.com by Pickle Rick (XRAD) · License: CC BY
Browse categories
Browse other part families
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Verified by drivers
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Comments (0)
Part lists
Ask the community about this part
Start a fitment, printing, or design discussion with this part already attached.
Related Parts
Most specific car + model + year + category matches first, with popular parts mixed in.
