'08 Kia Rio Manual Window Knob Replacement - image

Files (1)

Manual_Window_Knob.STL

STL

239.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Manual_Window_Knob.STL	Primary model	239.8 KB STL	Slice file	Slice file	Slice file	Ensure the print orientation allows for easy removal of supports, if needed.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

'08 Kia Rio Manual Window Knob Replacement

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I bought my '08 Kia Rio, but it lacked a knob for the manual window. Finding and adding the knob was a pain, so I just made one. I am sure this could work on many manual window armature and cabinets doors. The hollow shaft is 3mm x 11mm and is solid at 50% infill. The inner and outer diameter of the shaft is tapered for ease of installation. Hope this helps folks out.