Files (2)

1952_Plymouth_Gearshift_Knob_up.stl

STL

84.4 KB

1952_Plymouth_Gearshift_Knob_Ver_2.stl

STL

529.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 50%	100% solid	Recommendation
1952_Plymouth_Gearshift_Knob_up.stl	Printable file	84.4 KB STL	Slice file	Slice file	Slice file	Print with the large end down and the small end up for optimal results
1952_Plymouth_Gearshift_Knob_Ver_2.stl	Printable file	529.4 KB STL	Slice file	Slice file	Slice file	Print with the large end down and the small end up for optimal results

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

1952 Plymouth Gearshift Knob

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Gear shift knob for "3 on the tree" 1952 Plymouth. Should also work for 1952 Dodge, DeSoto and Chrysler. Note: This prints best with the large end down and the small end up. 50% infill, support material with 50% overhang threshold and a 2 layer raft. After printing, the knob must be tapped: 5/16" - 18 tpi 07/03/17: added another stl file with a knob that is closer to the original gearshift knob.