Files (3)

f0rd_handle.stl

STL

1.3 MB

f0rd_housing.stl

STL

1.7 MB

ranger_door.stl

STL

1.5 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
f0rd_handle.stl	Printable file	1.3 MB STL	Slice file	Slice file	Slice file	Ensure proper layer adhesion for a strong handle
f0rd_housing.stl	Printable file	1.7 MB STL	Slice file	Slice file	Slice file	Ensure proper layer adhesion for a strong handle
ranger_door.stl	Printable file	1.5 MB STL	Slice file	Slice file	Slice file	Ensure proper layer adhesion for a strong handle

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Handles

1992 Ford Ranger Door Handle

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Driver's inside door handle housing and handle itself broke off, or was broken when I was gifted this truck. Here's my fix! You'll see the first draft which was just a placeholder to see if the overall size was good. Good enough for me! I did adjust the height of the layers since there was a bit of a gap between each layer but still held up. I dropped each layer 1 mm on the next rendition and rounded a number of piece better. The cut outs for the cable and cable stop screw hole aren't perfect. Instead of going back to the drawing board I pulled out the drill and angle grinder. I also had to sand on the handle pivot end to slide around easy. The handle does pop out at times, but if you're mindful with pulling the handle and pushing it back in...no worries. Otherwise, feel free to modify and fix my design! All in all, it works!! And it's strong!!