Files (1)

Jeep_Dummy_Switch.stl

STL

447.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Jeep_Dummy_Switch.stl	Primary model	447.2 KB STL	Slice file	Slice file	Slice file	Print with a tight fit in mind to match factory switches

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

1998 Jeep Tj Rocker Switch Plug

0 downloads48 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I have some HID pod lights that I have recently installed in my 1998 Jeep Wrangler TJ. My Jeep was a factory soft top, meaning there are no switches or a wiring harness to control accessories on a hard top. To make my cheap switches look like a more "professional" job, I made 3 of these to replace the solid dummy ones that I would otherwise cut in the radio/dash bezel. They are a tight fit and look very similar to the factory ones when printed in black. I used 3 2-position rocker switches that have the 3 terminals on the back for female wire connectors. I do no know if they fit any other model Jeep because I made these to custom fit mine. They require no glue, fasteners, or attachment methods other than the clips on the switch and the retaining hooks on the 3d printed pieces.