Files (3)

Switch_Insert.stl

STL

537.1 KB

Switch_Panel_Left.stl

STL

102.5 KB

Switch_Panel_Right.stl

STL

103.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Switch_Insert.stl	Printable file	537.1 KB STL	Slice file	Slice file	Slice file	Print with the back side down to utilize the build plate for tab support
Switch_Panel_Left.stl	Choose left variant	102.5 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
Switch_Panel_Right.stl	Choose right variant	103.9 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Jeep TJ switch panel halves

0 downloads50 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

(Warning: I have printed this and as of right now cannot figure out how to install it into the dash properly, so if your looking for something to drop right in, do not waste your time printing it at the moment. I am working on figuring it out and will update it when a solution has been discovered) Switch panel for Jeep TJ. I separated it into 2 pieces so it can be printed on a 20x20 printer. This model is also scaled correctly unlike the original one. Print with the back side down so that the tabs are laying on the build plate. Use supports. Each half took me 12 hours to print. Once finished glue or weld both halves together and glue in the switch holder insert. The holes might need some sanding depending on how large your sockets are.