2015 Mitsubishi Mirage Speaker Adapter - image

Files (2)

Speaker_Adapter_v4.stl

STL

371.5 KB

Speaker_Adapter_v5.stl

STL

468.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Speaker_Adapter_v4.stl	Printable file	371.5 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping.
Speaker_Adapter_v5.stl	Printable file	468.9 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Panels

2015 Mitsubishi Mirage Speaker Adapter

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The speaker holes for the 2015 Mitsubishi Mirage are not standard. I designed this in Fusion 360 so that I can fit a set of cheap Sony 5 1/4 inch speakers from Wal-Mart in the front doors without drilling holes. I have not checked the back doors to see if they are any different. I am currently printing this and have not tested it yet. Will update once tested. ----Update----- The fit was a little tight, but it did go on and looks good. However, When trying to remove it the clips broke off. I filleted the bottoms of the clips and I am reprinting with a higher density (25%) infill and 4 perimeters instead of just 2.