2018 VW TIGUAN USB floating shelve - image

Files (1)

USB_floating_shelve.stl

STL

1.9 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA / / ABS 20%	PETG / ASA / / ABS 25%	100% solid	Recommendation
USB_floating_shelve.stl	Primary model	1.9 MB STL	Slice file	Slice file	Slice file	Use a short USB extender cable as recommended by the designer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

2018 VW TIGUAN USB floating shelve

0 downloads33 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

If you use a small size USB pendrive, it is very difficult to plug and remove because the original socket position are too deep in the dashboard. I created a floating shelve, with two socket of USB and the two side you can store your phone if you want. Have to buy a short USB extender cable. Only the middle top side glued (3M double side tape) on to the dashboard, the side cannot touch the plastic. (there is avoid the heat expanations isue and the rattling sounds also) More then one year I use in my car. I printed PETG, but also good ABS and ASA as well. The cable with I use you can buy here: https://www.pcx.hu/gembird-usb-a-m-f-adatkabel-hosszabbito-0-15m-fekete-ccp-usb2-amaf-0-15m--00954652