Files (3)

Flexbed_12v_Switch_Cover.stl

STL

94.1 KB

Flexbed_LED_Mount_One.stl

STL

99.4 KB

Flexbed_LED_Mount_Two.stl

STL

99.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Flexbed_12v_Switch_Cover.stl	Cover / cap	94.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
Flexbed_LED_Mount_One.stl	Mount / bracket	99.4 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
Flexbed_LED_Mount_Two.stl	Mount / bracket	99.4 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

2022 Ford Maverick Bed Lights

0 downloads44 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

More details in this blog post: https://mod.blog/2022/04/30/2022-ford-maverick-bed-lights/ These mounting clips are designed to nestle in on the tabs holding the plastic cover on the sides of the bed of your Ford Maverick. There's 8 on each side, so if you want to use every clip, you'll need 16 of Side One and 16 of Side Two. I included a cut-out on each side to fit a metal washer -- once that is in place, I used a 6-32 3/4" machine bolt to hold the two halves together with a wingnut on the other end. The LED light strip that this was designed to fit: https://www.amazon.com/dp/B08CDJK423 The switch that I used to control it, that fits in the included faceplate: https://www.amazon.com/dp/B08N4CBYLH