Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

370z Blank Button delete

0 downloads46 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

The purpose of this is to replace the ugly and useless blank buttons in front of the cup holder on the 370z. There is also a hole in the bottom so that you can run a USB cable through the bottom to charge your phone or connect to an aftermarket head unit. To install simply pull up on the cup holder, remove the 4 screws holding the blank panel in. Finally you can use a few dabs of epoxy on the outside of the piece to hold it in place, however you don't have to use epoxy, on my 370z it holds itself in place.