Files (1)

chBodyV2.stl

STL

206.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
chBodyV2.stl	Primary model	206.2 KB STL	Slice file	Slice file	Slice file	Print the body in a material suitable for outdoor or garage conditions, such as PETG.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

'99 Ford Ranger cup holder

0 downloads35 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG for the body and a heat-resistant material like ABS or ASA for the inserts

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for the body and 100% infill for the inserts

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I'm not sure about the automatics, but if you own this truck with a stick shift you probably battle with the abysmal cup holder placement, or you're like me and don't have any cup holders at all. I recently swapped the electronic x-fer case to a manual one and subsequently had to replace the center console with one that accommodates the second shifter and has zero cupholders. So I made this! The inserts are removable so that the body can be printed in PLA and the parts that touch hot drinks can be printed in something more heat resistant. Either insert can go in either hole.