Aménagement porte-gobelets Ford Ranger (Ford Ranger cup holders) - image

Files (2)

Gobelet_Ford_Ranger.stl

STL

75.5 KB

Porte_gobelets_Ford_Ranger.stl

STL

106.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 15%	100% solid	Recommendation
Gobelet_Ford_Ranger.stl	Printable file	75.5 KB STL	Slice file	Slice file	Slice file	Verify orientation and supports in slicer for optimal printing
Porte_gobelets_Ford_Ranger.stl	Printable file	106.3 KB STL	Slice file	Slice file	Slice file	Verify orientation and supports in slicer for optimal printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Aménagement porte-gobelets Ford Ranger (Ford Ranger cup holders)

0 downloads264 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is an arrangement for the front cup holders of the Ford Ranger (T7 and older) which makes better use of this space. I added felt pads below to make it softer, as well as a thin self-adhesive protection on the sides so as not to scratch the glasses or damage the objects. The printing is done in two parts: The general frame (Ford Ranger.stl cup holder) and the two cups (Ford Ranger.stl cup) which must then be glued. No support and low filling are OK. ------------------------------------------------------------------ Ceci est un aménagement pour les portes-gobelets avant du Ford Ranger (T7 et plus anciens) qui permet de mieux utiliser cet espace. J'ai rajouté des patins en feutrine dessous pour que ce soit plus doux, ainsi qu'une fine protection autocollante sur les parrois pour le pas rayer les lunettes ou abimer les objets. L'impression se fait en deux parties: Le cadre générale (Porte gobelets Ford Ranger.stl) et les deux gobelets (Gobelet Ford Ranger.stl) qu'il faut ensuite coller. Pas de support et faible remplissage sont OK.