Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| No printable model files are available for an estimate yet. | ||||||
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Alfa Romeo 159 Sunglasses Holder Latch
Shared by
3DPrintedCarPartDescription
This is a latch (circled in red on the second photo) for the sunglasses holder on the Alfa Romeo 159. It just clips into place. To get the old one out insert something fairly flat in next to it down to where you can see the bit of round clip/pivot point and then twist until it pops out. Mine broke at the tip and I could not find the piece that broke off so I did not have the exact measurements, but through few iterations I think it fits fairly well. The replacement seems to work better than the original one which would sometimes get stuck.
Compatible Cars
Originally published on thingiverse.com by Boris Cikota (Avise) · License: CC BY-NC-SA
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
