Alfa Romeo Mito cabin vent water cover - image

Files (1)

air_cover.stl

STL

126.4 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

18g

Based on 40% main infill across listed model files

Material cost

$0.42

Filament only at roughly $24/kg PETG / ASA

Print time

30m–50m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 40%	100% solid	Recommendation
air_cover.stl	Cover / cap	126.4 KB STL	13g $0.32	18g $0.42	31g $0.75	Use PETG / ASA; check sealing faces and supports unlikely.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Vents

Alfa Romeo Mito cabin vent water cover

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The ingenious designers from Alfa Romeo,at the Mito under the scuttle cover have a drain that prevents water from going inside the air vent for the cabin that is located there. The same drain however,if the rubber from the scuttle doesn't seal well with the windscreen,which is a thing after a couple of years,collects water and sends it inside the cabin through the air vents at the floor. As you can conclude after a heavy rain the passenger floor was a lake. This design prevents the water from going in there.It's not perfect but it does the job.I also placed some glue at the joins to secure just to be sure. Printed with no supports.I used PETG to make sure that heat won't bother it.