amplifier connector for BMW vehicle - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

amplifier connector for BMW vehicle

0 downloads92 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a 3d printable connector that allows you to replace the rear amplifier in a E46 BMW Harman Kardon system. No need to cut off the connector or splice wires, just plug and go. The factory retention and eject system for the connector is retained. This connector also applies to other cars (BMW) with the same audio system. I used a dual row 0.1" pitch header with some pins removed for the electrical contacts. The header was soldered to a carrier PCB and the wiring was then fanned out to the rest of the components. The.stp file is included for those that wish to modify the connector.