Files (8)

Bottom.stl

STL

892.6 KB

Box.stl

STL

1.1 MB

Lid.stl

STL

68.0 KB

Middle_part_riser.stl

STL

183.8 KB

Middle_part_riser_1cm_higher.stl

STL

184.4 KB

Middle_part_riser_1cm_lower.stl

STL

183.5 KB

Middle_part_riser_2cm_lower.stl

STL

179.1 KB

Sliding_Armrest.stl

STL

1.6 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

8 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 18%	100% solid	Recommendation
Bottom.stl	Printable file	892.6 KB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.
Box.stl	Printable file	1.1 MB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.
Lid.stl	Printable file	68.0 KB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.
Middle_part_riser.stl	Printable file	183.8 KB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.
Middle_part_riser_1cm_higher.stl	Printable file	184.4 KB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.
Middle_part_riser_1cm_lower.stl	Printable file	183.5 KB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.
Middle_part_riser_2cm_lower.stl	Printable file	179.1 KB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.
Sliding_Armrest.stl	Printable file	1.6 MB STL	Slice file	Slice file	Slice file	Verify final orientation and support decisions in your slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Armrest Toyota GR Yaris

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Put padding on top of the sliding armrest and cover with leather or fabric. - 2pcs M6 x 40 (max 50) for the hinge - 4pcs M4 x 40 for the sliding piece - 4pcs 5,3 x 20 washers for the screws holding the sliding piece Outer walls/perimeters: at least 3 Layer height: 0.3mm (it takes a looooot of hours to print all parts even at that height) Infill: 15-20% works fine No supports https://www.youtube.com/playlist?list=PLyJjY3xL9fgz-PqQDJ7FIqQcfAfLj0LqI