Files (2)

Support_tel_A3_7deg_inclinaison.stl

STL

291.8 KB

Support_tel_A3_r├⌐hausse_tous.stl

STL

344.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Support_tel_A3_7deg_inclinaison.stl	Printable file	291.8 KB STL	Slice file	Slice file	Slice file	Use a heated chamber if available to improve layer adhesion
Support_tel_A3_r├⌐hausse_tous.stl	Printable file	344.5 KB STL	Slice file	Slice file	Slice file	Use a heated chamber if available to improve layer adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Audi A3 Phone holder

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

After printing the original model in PLA and using it for few months, it begins to bend cause of the heat of the car. I modified it to reinforce it and covered it with real carbon fiber to make it stronger and look nice. I had some angle to the support of the magnet to turn a little bit ( 7 degrees) the phone in the driver's direction. I add a file with 4 sizes of the support of the magnet: - 10mm with 7 degrees angle - 10mm straight - 8mm straight - 5mm straight.