Files (1)

Audi_Q5_iPhone_XS_Max_1.stl

STL

8.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Audi_Q5_iPhone_XS_Max_1.stl	Primary model	8.5 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Audi Q5 iPhone XS Max Holder

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

A basic iPhone XS Max cradle made to fit in the wedge opening on the Audi Q5 console. The XS Max is too big to fit in there as designed, and then you can't see it well. The object has a channel made in it for a normal cable to run through from either direction, and go to the cradle part for connecting the USB cable. The angle is flat; will probably remix this later to angle the cradle towards the driver more for visibility. But the important thing is I get a cupholder back! You absolutely need to print this with supports of some sort. In Cura, I used "touching Buildplate", with a support overhang angle of "10". Support pattern of "lines". It came apart very cleanly and without issue. (Note: the picture shows an iPhone XS, not Max, in the holder).