iPhone XS Max phone holder for Audi Q5 - image

Files (1)

phone_holder_2.stl

STL

276.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
phone_holder_2.stl	Mount / bracket	276.9 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

iPhone XS Max phone holder for Audi Q5

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

New Phone, New problems. The iPhone XS max did not have a home in my Audi Q5. The nook I used to put my old iPhone was not large enough and everytime I took a turn, the phone would go flying. I took to fusion360 with some measurements and with some draft prints I came up with a design that worked perfectly. This phone holder should fit most phones without a case or with a very minimal case.