Audi TT 8N MK1 - 52mm Gauge Vent Mount - image

Files (3)

52mm_deep_gauge_adapter_-_shorter.stl

STL

167.9 KB

52mm_Deep_Ring_for_Audi_Vent_Gauge.stl

STL

320.4 KB

Extra_Ring_for_52MM_Gauge.stl

STL

7.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
52mm_deep_gauge_adapter_-_shorter.stl	Printable file	167.9 KB STL	Slice file	Slice file	Slice file	Use a brim or raft for stability during printing
52mm_Deep_Ring_for_Audi_Vent_Gauge.stl	Printable file	320.4 KB STL	Slice file	Slice file	Slice file	Use a brim or raft for stability during printing
Extra_Ring_for_52MM_Gauge.stl	Accessory piece	7.9 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Vents

Audi TT 8N MK1 - 52mm Gauge Vent Mount

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of the one made by WachuTT. It is redesigned to allow air to pass through the vent around the gauge and will work with a "52mm" gauge. The opening is actually 54mm as the AutoMeter gauges I have pictures here needed that amount. I don't know if that was just those or not. I also included an extra ring that allows the gauge to push forward further to be flush with the silver cover. I used two on each gauge so it is even and not set back. There is a deeper one which matches the original one by WachuTT but I ended up making a shorter one so I could use the adapter that came with the gauge to lock it onto it. You'll see what I mean once you purchase the gauges. I recommend an epoxy to glue the silver cover to the 3d printed mount. I made mine out of ABS for the possible heat on a hot summer day in the car and it worked fine with a raft and supports. The supports are a bit of a pain to get off but not impossible and the finished product afterwards is worth it. Be careful though, the overhanging lip is thin and will crack. I broke one that way by pushing too hard when trying to remove the supports the first time.