Files (2)

e91_rear-wiper-cap7.stl

STL

4.2 MB

wiper-cap-tool.stl

STL

1.0 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
e91_rear-wiper-cap7.stl	Cover / cap	4.2 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
wiper-cap-tool.stl	Cover / cap	1.0 MB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

BMW E91 Rear Wiper Delete Cap

0 downloads75 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This cap is used to delete the rear windshield wiper on 2007-2011 BMW 3-Series wagons. The wiper shaft is removed but the handle and glass-opening button remain for convenience. The cap model has build-in support that can be broken away with pliers. I included a tool that can be used with a drill to sand and polish the cap. My prints snap onto the large hex nut, but your print results may be different depending on your settings and printer model. You can either scale the model up/down slightly for fitment, or use some silicone if desired.