Files (1)

Faceplate_i3_V1.4.stl

STL

1.8 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ASA / PETG 20%	ASA / PETG 25%	100% solid	Recommendation
Faceplate_i3_V1.4.stl	Primary model	1.8 MB STL	Slice file	Slice file	Slice file	Ensure proper bed adhesion due to the part's shape and size

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

BMW i3 Faceplate DTC button

0 downloads63 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a faceplate for a BMW i3 where the DTC button was retrofitted from a BMW i8. The existing faceplate misses the hole for the DTC button. Made with ASA for higher car temperatures, the clips on the side are a little bit thicker to prevent easy breaking. It's a little bit tight during installation, but feasible. I used 260 degrees C, 100 degrees C for the bed, slow print, 0.15 mm layer height and a little bit overextrusion of 3-5% for better layer adhesion. I enclose the Freecad file, so you ca easily adapt any changes. Have fun!