Files (1)

Simple_phone_car_mount_v7.stl

STL

158.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 20%	100% solid	Recommendation
Simple_phone_car_mount_v7.stl	Mount / bracket	158.8 KB STL	Slice file	Slice file	Slice file	Ensure the phone holding jaw is oriented for optimal flexing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Car phone mount

0 downloads33 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I made this part because I was annoyed by the lack of options that were available. They all either block the air vents or have some sketchy arm to hold the phone. This part is designed to press into a trim gap in a car and features a small clip to prevent it from falling out. The phone holding jaw flexes open and holds the phone in place. Part is printed with 4 outer walls, 2 or 3 top and bottom walls, and 20% infill, just enough to make sure the two layers don't separate when repeatedly flexed. This is only made to fit a single phone and car, 1st gen Mazda 3 and Samsung Galaxy 10, so some if not all dimensions will need to be changed to fit a different installation.