Files (3)

Case.stl

STL

87.4 KB

pin.stl

STL

16.9 KB

sphere.stl

STL

51.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Case.stl	Printable file	87.4 KB STL	Slice file	Slice file	Slice file	Print with a high enough infill to support the weight of the phone
pin.stl	Accessory piece	16.9 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
sphere.stl	Printable file	51.9 KB STL	Slice file	Slice file	Slice file	Print with a high enough infill to support the weight of the phone

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Cellphone holder for 2010 RAV4

0 downloads28 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Its a cellphone holder for a Samsung S10e (with case) for a 2010 Rav4. May work for other vehicle years or cellphones also (mileage may vary). The chances you need this design are 0%, but, in case you do, here it is. May also work with with other phones (print at your own risk). This fits my Pixel 3XL without case. The 2010 Rav4 has two spaces on the front dash (to the top left and top right of the stereo). One of these spaces is typically used by the emergency light button. The other space is typically plugged up. This will go in place where the plug is. YouTube how to remove the that left panel; its easy to pop off from the bottom with a flat screwdriver if you know how. Then just screw it in from the back. Don't use PLA for printing if you live a hot climate. The square box goes on the rear of the panel and the cylinder goes on the front of the panel. Sandwich both of these together with the panel in the middle.