Citroen DS3/C2/C3 Parcel Shelf Peg / Clip - image

Files (1)

625citreon.stl

STL

40.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
625citreon.stl	Primary model	40.5 KB STL	Slice file	Slice file	Slice file	Ensure a snug fit by checking the dimensions against your vehicle's parcel shelf

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Citroen DS3/C2/C3 Parcel Shelf Peg / Clip

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Spare Peg to hold the rope on a DS3 Parcel shelf. From looking up third party and official clips they appear to also be identical on the C2 and C3 so I am assuming they will also work there. I have only tested them on my DS3. These appeared hard to find in the UK - so took out my remaining one and with my callipers and 10 minutes in tinkerCAD came up with this. It's printed to 6.25MM for the width of the peg which showed up as 6.20mm on my callipers, but it fits snuggly into my car and holds the rope tight, its a bit harder to get the rope loop over than on the original but it won't come off by accident.