Files (1)

Bottom.stl

STL

15.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Bottom.stl	Primary model	15.9 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

cup holder for BMW 1 Series

0 downloads27 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for better heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for durability and weight reduction

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

Safety/IP review

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Since my BMW 118d did not come with a cup holder and the 3rd party cup holders to put into the louvers where not particularly pretty or stable enough to hold heavier mugs, I decided to design and printed one myself. The model should work for all BMW 1 Series with this kind of center console and the steering wheel on the left side I guess. I also added a coin holder for shopping carts with a 50 Cents (€) coin in mind. The model is split into two parts to compensate for my small build volume. I printed the model on the photos in PLA what is sufficient for the cold temperatures right now but I guess for a better resistance to higher temperatures in summer I will have to print it again in something more heat resistant like PETG. There was a little bit of under-extrusion going on at the bottom part in one spot as you can see on the picture (light spot) but I am ok with that since I have to reprint it again in summer anyway. I installed the model by simply adding some double sided tape underneath it and it holds up rock solid so far. Print Settings Printer Brand: Monoprice Printer: Select Mini Rafts: No Supports: No Category: Automotive.