Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 30% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| CupHolder.stl | Mount / bracket | 625.3 KB STL | Slice file | Slice file | Slice file | Print with a layer height of 0.3mm or finer for better detail |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Cup Holder - Mazda CX-5
Print this part
Check the available model and saved setup details before opening your slicer.
Files
1 hosted model file
STL
Material
PETG or ASA
Print time
Slice to calculate
Filament
Slice to calculate
Supports
verify in slicer, likely needed for the connector ends
Infill
30% for the main body, 100% for the connector ends
Difficulty
Not rated — inspect geometry
Vehicle heat
Cabin/interior use; avoid high-heat zones
Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
Anyone who owns a Mazda CX-5 will know that the location of the console cupholders is terrible. I designed this cupholder to fit in the very narrow slots of the vents and use the jut-out below the vent to support the weight of the beverage. These were printed in PLA, however PLA will sag over time. I have re-printed them in PETG for better resilience to the sun and extreme temps. These are designed in two pieces so that they can be printed without any supports on the main body. That said, supports should be added to the end of the arms that hook on to the vents. I used Cura to modify settings for just the connector portion to 100% infill and supports. Layer height:.3 or finer Infill: 30% Except arms where set to 100% (See pics) Recommended filament: PETG, PC, ASA, ABS, etc. Notes: NOTE: Supports are NOT required on main body... just the connector ends.
Compatible Cars
Originally published on printables.com by Barry Willick · License: CC BY
Browse categories
Browse other part families
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Most specific car + model + year + category matches first, with popular parts mixed in.
Cup Holder - Mazda CX-5
Yeti Cup Holder (for '21 Mazda CX-5)
Frank Green Cup Holder Adapter Mazda CX-5
Mazda MX5 ND Cup Holder Storage (passenger side)
Mazda MX5 ND - Storage Bin for Cup Holder (RHD)
2004-2010 Hyundai Sonata Headlight Dust cap
Hyundai
