Cupra Charger Holder (Cupra Leon 4KL) - image

Files (2)

Cupra_Charger_Holder_L.stl

STL

190.5 KB

Cupra_Charger_Holder_R.stl

STL

180.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 18%	100% solid	Recommendation
Cupra_Charger_Holder_L.stl	Mount / bracket	190.5 KB STL	Slice file	Slice file	Slice file	Print with the part laid on its side wall without hexagonal cutouts for minimal support
Cupra_Charger_Holder_R.stl	Mount / bracket	180.2 KB STL	Slice file	Slice file	Slice file	Print with the part laid on its side wall without hexagonal cutouts for minimal support

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Cupra Charger Holder (Cupra Leon 4KL)

0 downloads42 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I was frustrated by having the Hybrid EV charging cable and "brick" lying around on the floor, so I quickly drew up a holder for the charging brick. For wall mounting you can also add some washers between wall and holder, so the Charger stays nice and cool. The charger is probably comparable or the same for all of VWs Hybrids for the current model year 2021 / 2022 (so e.g. VW GTE, Skoda Octavia RS iV, Cupra Formentor, etc.). Additionally I used the the nice EV Type II Plug and Cable Holder from mat_neu27 -- > https://www.thingiverse.com/thing:4153588 Printing: The part is cut in half to ensure printing without a lot of supports. I recommend laying the parts on the side wall (without the hexagonal cutouts). In that case you will just need some supports for the first few layers, depending on your layer height. My settings (Cura): - Nozzle Size: 0.5mm - Layer Height: 0.4mm - Printing Speed 60mm/s (1st layer 30mm/s for adhesion) - 3 walls - 15% infill Gyroid - Support overhang Angle: 55 - 60 degrees Printing time ~3.5 hours per part.