Dashboard Speaker Adapter for Toyota GT86/Scion FR-S/Subaru BRZ - image

Files (2)

Speaker_Adapter_Dashboard_right_V02.STL

STL

5.0 MB

Speaker_Adapter_Dashboard_left_V02.STL

STL

5.0 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ABS 20%	PETG / ABS 100%	100% solid	Recommendation
Speaker_Adapter_Dashboard_right_V02.STL	Choose right variant	5.0 MB STL	Slice file	Slice file	Slice file	Use PETG / ABS, 4 walls, 100% infill. Pick the matching side before printing.
Speaker_Adapter_Dashboard_left_V02.STL	Choose left variant	5.0 MB STL	Slice file	Slice file	Slice file	Use PETG / ABS, 4 walls, 100% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Dashboard Speaker Adapter for Toyota GT86/Scion FR-S/Subaru BRZ

0 downloads51 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a Dashboard Speaker Adapter for Toyota GT86/Scion FR-S/Subaru BRZ. It is a full redisign of Schankenstein´s Speaker Adapter. It also features a rainshield, which is allways very important to have. It is made for a Andrian Audio A80neo and a A25/A25T/A25G speaker. It includes a 30ml coupling volume for tweeters with drilled core. (as the A25G) Since speakers it is designed for use standardized dimensions, it should fit many other models. Status: -V02 Printed and tested -> works fine, OEM speker cover need to be cut back slightly (see pictures) Instructions: -Use PETG or ABS. Materials like PLA will not withstand the heat and stress of this application. Furthermore, accoustics could be affected in a negative way. -Use supports. Printbed touching, 70° overhang angle. -Print with 100% infill, but take care to really use infill and not maximum bottom layer count. (in CURA) Set bottom layer / top layer count to 3. Otherwise you might get a slow and/or a weak print. -Make sure to use a good overlap between infill and inner wall to get a strong print. -Use zig zac or lines as infill patern to get a strong print. Do not use concentric patern. Installation: -drill hole(s) for tweeter cable as necessary -OEM tweeter mount needs to cut off sligthly (see pictures) -use 3 plastic rivits for fixation -form a proper volume for midrange speaker above air duct by use of butyl plates -close gaps arround adapter to create sealed volume for midrange speaker.