Electric Power Steering Pump Power Connector for Mini Cooper - image

Files (1)

PowerStearingPumpConnector.stl

STL

18.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
PowerStearingPumpConnector.stl	Primary model	18.8 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Electric Power Steering Pump Power Connector for Mini Cooper

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Electrical connector for a electric power steering pump from a 02-08 Mini Cooper. You will need 18g wire and two male spade connectors. First print the connector then remove the sleeves from the spade connectors and crimp them on to your wires, optionally you can add a drop of solder to each crimp. Next add a 10 degree bend to the spades and feed the wires in through the front of the connector and pull them through. Lastly add a shrink tubing and your all good to go. Plug the connector into your power steering pump and power the unit up! If you need a control port plug look at the second connector to this pump here ==> https://www.thingiverse.com/thing:4671991