Files (2)

cap.v2.stl

STL

1.9 MB

logo-v2.stl

STL

558.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
cap.v2.stl	Cover / cap	1.9 MB STL	Slice file	Slice file	Slice file	Use PETG; check sealing faces and verify in slicer.
logo-v2.stl	Printable file	558.1 KB STL	Slice file	Slice file	Slice file	Print the Ford logo first with a skirt for better adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

F150 - 2015 Center Cap

0 downloads48 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a center cap for a 2015 Ford F150. --- UPDATE v2 files are a much better fit. I highly recommend using PETG for this print. PLA is too stiff. The clips will snap when trying to put the center cap in the rim if printed in PLA. PETG can bend just enough to where the cap will clip in and stay. ### Multi-color --- I used the technique shown off in this youtube video to achieve a multi-colored print. ### Adhesion & Supports --- I printed the Ford logo first with a skirt. Once that was done printing I removed the skirt and printed the cap. I made sure to block supports on the cap where the Ford logo is to avoid the cap trying to print supports there and so that the only supports printed would be the ones for the tabs that stick out.