Files (4)
Choose the needed variant and slice it; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 40% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| F150RockerCapsv5.stl | Cover / cap | 35.6 KB STL | Slice file | Slice file | Slice file | Use PETG / ASA; check sealing faces and supports likely, verify in slicer. |
| F150RockerCapsvTPU.stl | Cover / cap | 54.0 KB STL | Slice file | Slice file | Slice file | Use PETG / ASA; check sealing faces and supports likely, verify in slicer. |
| F150RockerCapsvTPU40mmfront.stl | Cover / cap | 54.0 KB STL | Slice file | Slice file | Slice file | Use PETG / ASA; check sealing faces and supports likely, verify in slicer. |
| F150RockerCapsvTPU46x25.stl | Cover / cap | 74.3 KB STL | Slice file | Slice file | Slice file | Use PETG / ASA; check sealing faces and supports likely, verify in slicer. |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
F150 Rocker hole plugs 2009-2014
Shared by
3DPrintedCarPartDescription
Plugs to go in the factory holes along the inside of the rockers on the 2009-2014 Ford F150's These holes are covered by tape from the factory, this tape eventually falls off and allows road grime and salt into the rockers which then rusts out. try print a few between 100% and 99% scale as some of the hole sizes varied slightly I used supports for these prints Also added TPU versions which seal much better, should work great for keeping road salt out over winter.
Compatible Cars
Originally published on thingiverse.com by Josiah Whitefield (Problex) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
